Micromod RetroPAK: SLC Configuration Manual - Manual (Page 34)

Command Series Migration to MOD 30ML
Function Codes – Introduction
• Click on the Setpoint tab to select the Setpoint configuration options. See the next figure:
• Change the Setpoint limits to desired values. Setpoint values to the PID algorithm are
limited to these numbers.
• Setpoint modes limited is used to apply limits to the setpoint when it is in a certain mode.
The limits can be applied to: None, Local, Remote, Track or their combinations. See the
next figure:
Figure 1 .21.
PID Setpoint Tab
1 - 26