DoorKing 1812 Access Plus - Manual (Page 29)

1812-162-M-1-12 27
The 1812 Access Plus can be programmed from a computer, the system keypad (Keypad on the 1812) or from a touch-tone
telephone connected to the system.
We highly recommend programming the 1812 Access Plus from a computer using the DoorKing 1812 Management software as
this greatly simplifies the programming task (See section 2.3 for more information). There are also several features in the 1812
Access Plus system that MUST be setup using a computer.
The following features and programming parameters can only be programmed from a computer:
Strike Out: This feature can be turned ON or OFF and will set the number of invalid access codes allowed before the system
shuts down for a period of time. The default is OFF.
Holiday Schedules: Program up to 31 different Holiday schedules. This feature can be turned ON or OFF. The default is OFF.
Email Notification: Set the 1812 to send emails to a specified email address on events of your choice. Requires an Internet
connection. This feature can be turned ON or OFF. It comes from the factory with this feature turned OFF (factory setting OFF).
Note: When the mail server uses SSL (Secure link), the 1812 cannot send e-mails.
Transaction Log: Download and view the system transaction log.
Computer - PC’s only, NOT for use with MACs
This is the preferred method of programming the 1812 Access Plus as it will simplify all of the programming steps
and allow you to enjoy all of the features and benefits available with this system. The 1812 Management software must
be installed on your computer and the 1812 must be connected to the computer via one of the methods shown in section
1.12.2 or 1.12.3. Refer to the 1812 software help screens for more information.
System Keypad
We strongly recommend that you become familiar with the entire programming sequence before attempting to program
some of the more complex features of this system using the system keypad. If you make a single error in the program-
ming steps, you will have to re-do the sequence from the beginning.
Touch-Tone Telephone
The programmable features that can be programmed using the system keypad can also be programmed using a touch-
tone telephone (typically the house phone) connected to the 1812. This method of programming is useful for program-
ming simple steps or for turning certain features ON or OFF, but is not recommended for complex programming steps.
•
•
•
2.2 Programming Methods
77 8 9
4 5 6
1 2 3
0
1111 2222 333333
SOFTW
ARE
INST
ALLED
Direct “System Keypad”
Computer connected directly
to the system or the internet.
Touch-Tone Telephone
connected directly to
the system or off-site.