DoorKing 1812 Access Plus - Manual (Page 44)

1812-162-M-1-12 42
2.8 Miscellaneous
2.8.1 Restore Factory Settings
This step will restore the factory settings for each of the programming parameters. See the “Quick Reference Table” on
page 31 for all of the factory settings. The master code (2.1) will remain intact after the factory settings have been restored.
WARNING: Once started, this sequence will program all values to factory settings.
1. Press * 9 0 and enter the MASTER CODE. [ * 9 0 _ _ _ _ (beep)]
2. Press 9 9 9 9, then press * . [ 9 9 9 9 (beep)]
3. The programming sequence will end itself automatically. [beeeeeep]
2.8.2 Erase Transaction Log
This step will erase (empty) the transactions stored in the system history buffer (the system stores up to 500 transactions).
WARNING: Transaction log cannot be recovered after this sequence is started.
1. Press * 9 1 and enter the MASTER CODE. [ * 9 1 _ _ _ _ (beep)]
2. Press 9 9 9 9, then press * . [ 9 9 9 9 (beep)]
3. The programming sequence will end itself automatically. [beeeeeep]