Nova-Tech pH-CON 10 - Manual (Page 20)

Instruction Manual PC 10
- 16 -
6 . H O L D F U N C T I O N
This feature lets you freeze the value of the pH or
conductivity reading for a delayed observation.
HOLD can be used any time when in MEAS mode.
1. To hold a measurement, press the HOLD key
while in measurement mode. “HOLD” will
appear on the display.
See Figure 25.
2. To release the held value, press HOLD again.
Continue to take measurements.
NOTE: This meter will hold a reading for up to
20 minutes, after which time the meter will automatically shutoff to
conserve batteries without retaining the value that was held.
Figure 22: HOLD function
http://www.novatech-usa.com/Products/Laboratory-Equipment-Supply-Products Tel: (281) 359-8538 Toll Free:(866) 433-6682