E-Mon E50-6003200J*-N-KIT - Manual (Page 37)

GREEN CLASS NET METER
37 62-0416-01
10.1 Display Board Push Buttons (continued)
To access any of these items press the MENU button. The list will be displayed and an
arrow will appear to the left of LOAD CONTROL. To scroll down the list press the
MENU button until the desired item is indicated by the arrow. Then push the SELECT
button to enter the configuration screen for that item. The UP and DOWN buttons can
then be used to change the configuration field that is flashing. To change to a different
field push the SELECT button again. After all changes have been made the display will
return to scrolling after approximately 20 seconds.
Load Control
Load control parameters can be entered using the Load Control menu.
Date & Time Select this field to set month, day, year and time
Device ID
Select Device ID to change the default setting. The default setting is 1A for EZ7 and 1
for ModBus.
IP Settings
The IP Settings menu allows you to select DHCP or static IP address. The static IP
address, mask and gateway information can be entered using this menu.
BACnet Settings
The BACnet settings menu allows you to select and change the BACnet setting. To
reset, press the MENU button. Press the Up/Down Buttons until the BACnet Settings
line is selected.Press the SELECT button to enter the BACnet setting screen. Then,
use the up/down keys to change the setting. Then press the Select button to enter the
new setting. Peak Demand Reset
To reset the recorded peak kW demand, press the MENU button until “Reset kW/ kWh
Read” is indicated by the arrow on the display.
Press the SELECT button.
Reset kW only? N
Reset all? N
Will appear on the display. Press the UP button to change the N to a Y after “Reset kW
only?”.
The peak demand will be reset to zero and the meter will return to its normal scrolling
display mode.
Reset all will reset kWh as well as kW.