E-Mon E50-6003200J*-N-KIT - Manual (Page 38)

GREEN CLASS NET METER
62-0416-01 38
COST/CO2 Settings
To SET THE COST / CO2, press the MENU button until “COST / CO2” is indicated by
the arrow on the display.
Press the SELECT button.
Set the COST/KWH and CO2/KWH.
Display Hold Feature
You can “lock” the scrolling display so that it will stay locked on any one of the six
screens. On the inside of the door, locate the 4 buttons at the top of the Display Board:
Down, Up, Select and Menu. (These buttons are illustrated on page 26.
To stop the display from scrolling, follow these instructions:
The Select button is used to lock the meter’s display so that it stops scrolling and the
display remains on one screen.
Use the Up and Down buttons to choose which of the six screens you would like to
display.
Press the Select button. At the top of the display, you will see the message HOLD1.
This will lock the display for 1 HOUR.
NOTE: The display hold feature has different selectable time periods.
Pressing Select again will show the message HOLD6. This will lock the display for 6
HOURS.
Continuing to press the Select button will provide additional timing choices:
HOLD12: Locks the display for 12 HOURS
HOLD24: Locks the display for 24 HOURS
HOLD: Locks the display indefinitely
To exit the HOLD mode:
Press the Select button as many times as needed until the HOLD message disappears
from the display, or simply press the CPU RESET button located near the right center
of the CPU board.
** Be sure to exit from the HOLD mode when you are done using this feature.