Ramp installation – Fairbanks MATRIX SCALE HIGHWAY SCALE SYSTEM User Manual
Page 25
Advertising
Section 3: Installation
11/12
25
51182 Rev. 2
RAMP INSTALLATION
• Each ramp has two (2) bolt down tabs as part of the ramp.
• Shims are not included with the ramps and must be supplied.
• No more than two (2) ramps, located on opposite sides of the platform, may be
installed.
Place the ramp against the approach frame.
1. Make the ramp stable and level against the scale frame.
2. Bolt the ramps to scale frame using the supplied hardware.
3. Drill and anchor the ramp(s) using the supplied 3/4” wedge anchors.
Bolt the Ramps to the Approaches
Bolt-Down Tab
Advertising