Ransburg PulseTrack2 A11515-XXXXX - Manual (Page 30)

>The AC power must be cycled for the
new dip switch setting to be recognized.
NOTE
Temperature/Humidity Card
There is also a 4 position dip switch SW2 located
near the bottom of each temperature/humidity
card. These dip switches should always be set
to the OFF position.
Rotary DIP Switch
There is a rotary DIP switch SW1 located on each
Atomizer and Temperature/Humidity Card (see
Figure 11). The setting of this switch must match
the slot number the card is occupying as listed on
the label inside the front panel door (reference
Figure 18).
Figure 11: Atomizer Card Dip Switch
6" Conical Disk
6" UniDisk
8" UniDisk & 9" Conical Disk
10" UniDisk
12" UniDisk & 12" Conical Disk
Standard Aerobell
Aerobell 33 (30 & 57mm)
Rotator Type SW2-2 SW-2-1
OFF
ON
ON
ON
ON
OFF
OFF
TABLE 7 - ATOMIZER CARD SW2 DIP SWITCH SETTINGS
OFF
OFF
OFF
OFF
ON
OFF
ON
SW2-3
OFF
OFF
OFF
ON
OFF
ON
OFF
OFF
OFF
ON
OFF
OFF
ON
ON
Maximum
Speed
40,000 rpm
27,000 rpm
23,000 rpm
15,000 rpm
15,000 rpm
60,000 rpm
50,000 rpm
SW2-4
Ordering
Configuration
A11515-XXX1X
A11515-XXX4X
A11515-XXX5X
A11515-XXX6X
A11515-XXX7X
A11515-XXX2X
A11515-XXX8X
A11515-XXX3X
A11515-XXX9X