Gilderfluke&Co 8 Bit Digital Audio Systems - Manual (Page 18)

Front Panel Adjustments, Inputs & Indicators:
Several adjustments and indicators are available on the front panels of
the AB-100, AB-Clock, DR-50 and AB-50. The front of an AB-100 or AB-Clock
is shown below:
AB-100 AudioBrick
Gilderfluke & Co.
Glendale, California
Set
Clock
Manual
Start
Start Inputs
Running
Delaying
Bass
Treble Check
Date
Volume
Heart
Adjustments:
The following adjustments are available on all of our Digital Audio
Repeaters:
Volume: This control sets the volume of the output from the Repeater.
This adjustment is available on the AB-100, AB-Clock, DR-50 and AB-
50.
Treble: This control is used to adjust the level of the high end of the
Shelving Equalizer. This adjustment is available on the AB-100, AB-
Clock, DR-50 and AB-50.
Bass: This control is used to adjust the level of the low end of the
Shelving Equalizer. This adjustment is available on the AB-100, AB-
Clock, DR-50 and AB-50.
Inputs:
The 'Manual Start' Button on the front of each AB-100 or AB-Clock feeds
directly into the Digital Audio Repeater's circuitry, and so doesn't light the
'Start' LED. Other than this one detail, the Manual Start Button acts just like
any other 'Start' input. It can be configured identically.
ÔSet ClockÕ Button: An AB-Clock adds two additional recessed buttons
that are used to check and set the clock. You must use the end of a pencil
or paper clip to press this button. This button is used to set the clock. Each
time you press it, the minutes will be incremented by one. If the ÔCheck
DateÕ Button is held in when this button is pressed, then the hours will be in-
cremented.
ÔCheck DateÕ Button: An AB-Clock adds two additional recessed buttons
that are used to check and set the clock. You must use the end of a pencil
or paper clip to press this button. This button is used to check the date. The
first single digit is the day of the week (1-7). If it is pressed in and held, the
ÔSet ClockÕ Button will advance the hours of the clock each time it is
pressed.
ÔDefault ReloadÕ Button: The AB-100 and AB-Clock have a button hid-
den inside the case which is used to reload the default configuration on the
repeater. It is labeled as DIPSW1-2. To use it you must:
a) Power down the AB-100 or AB-Clock. You should always do this by
unplugging the power supply from the wall rather than unplugging
the 5 pin DIN connector at the AB-100/AB-Clock.
b) Remove the AB-100 or AB-Clock case top.
G ILDERFLUKE & C O . ¥ 205 S. F LOWER ¥ B URBANK , C A 91502-2102 ¥ 818/840-9484 ¥ 800/776-5972 ¥ F AX 818/840-9485
10 of 72