Gilderfluke&Co 8 Bit Digital Audio Systems User Manual

Page 25

Advertising

system.

All cards in the system must be set to the same baud rate. The default

speed is 9600 baud. This command doesn't take effect until you enter the
eXit command.

¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥

"c"

Odd Parity Toggle:

This toggle enables the ODD PARITY data check on the serial port for this

Repeater. Parity is a method of confirming that the data sent to the audio
system arrives intact. Any data that gets jumbled is ignored. If ODD PARITY is
enabled, it must be enabled on all the cards in the system as well as on
your computer or terminal. The default value for this command is off. This
command doesn't take effect until you enter the eXit command.

"d"

Eprom Type:

If the repeater is playing snippets of the sound you have burnt into a set

of Eproms and repeats each section 2, 4 or 8 times, then this variable is set
improperly for the type of Eproms you have installed. The following types of
Eproms are currently supported by the digital audio Repeaters Repeaters:

27C512
27C010

(default setting)

27C020
27C040
27C080

All the Eproms on a card must be of the same type. Different cards in the

same system can each have different types of Eproms on them. This com-
mand doesn't take effect until the eXit command is completed.

"e"

Inputs Debounce:

This command allows you to set the number of times the software inside

the Digital Audio Repeater will check any inputs before it actually believes a
change has happened. A typical value is 0A. If you experience multiple
triggers on any input, just raise this number until the problem disappears.

"f"

DR-400 Mode:

NOT USED WITH AB-100 AudioBrick: This toggle should only be turned on

only when operating on a DR-400 Audio Processing Cards. It disables all of
the commands which DR-400Õs canÕt (or shouldnÕt) use. This saves you the
time of turning all of these off individually.

"g"

Select From Aux.:

If more than one recording is stored on a single Digital Audio Repeater

card, each separate recording is referred to as a spiel. Each spiel can be
accessed individually and played back. Up to 255 of these spiels can be
stored on a single Digital Audio Repeater card. These requests can be
made through the serial port or through the AUX PORT.

This toggle enables the auxiliary port for requesting the spiels on this card.

There are two methods of selecting spiels from the AUX PORT. Which one is
used is selected by the next command.

"h"

Direct Select:

ILDERFLUKE

& C

205 S. F

LOWER

URBANK

, C

91502-2102

818/840-9484

800/776-5972

818/840-9485

17 of 72

Advertising

Popular Brands

Popular manuals