Gilderfluke&Co 8 Bit Digital Audio Systems - Manual (Page 55)

BYTE 1031 = LINE FEED
¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥
"O" Reload Defaults:
This command is used to part or all of the memory back to its default sta-
tus. When it is invoked it asks:
Ò1= clear only menu, 2=clear this schedule, 3=clear all schedules (1-3)-Ó
Hitting #1 will only clear out the variables that appear on the main
menu. Hitting #2 will only clear out the schedule that is currently being dis-
played on the main menu. Hitting #3 will clear out all eight of the sched-
ules.
¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥
"x" or "X" eXit Setup Mode:
This command is used to exit the setup mode. If you hit this command in
error, hitting an <ESC>ape key will get you back to the setup mode. All the
setup commands that don't take effect immediately, take effect when the
eXit command is entered. This includes things like the BAUD RATE, so you will
have to change the baud rate of the terminal you are using at this time.
The eXit command asks you if you want to save the current setup perma-
nently. If you answer 'Y', the EEprom will be written with the current configu-
ration. If you answer 'N', the setup mode will be exited without writing to the
EEprom.
Note that the operating hour schedules are written to the EEprom as they
are entered.
G ILDERFLUKE & C O . ¥ 205 S. F LOWER ¥ B URBANK , C A 91502-2102 ¥ 818/840-9484 ¥ 800/776-5972 ¥ F AX 818/840-9485
47 of 72