IAI America ERC2 - Manual (Page 40)


2. Installation
17
2.2 Installation
2.2.1 Slider Type
z Installing the actuator
The actuator-mounting surface must be a machined surface or have an equivalent flatness.
The side and bottom faces of the actuator base are parallel with the guides. If high slide accuracy is required, install
the actuator by using these surfaces as references.
(Note) Reduced flatness due to installation of an overhang load will cause the base to deform and inhibit smooth
movement of the slider. If the slider movement becomes heavier on the motor end or the slider begins
generating noise, correct the flatness. Otherwise, the slider mechanism may end its life prematurely.
Install the actuator in the mounting holes provided in the base.
Secure the actuator in place using M4 hex cap bolts.
Slider type