IAI America RCP4-RA6R - Manual (Page 14)

8
Precautions
1. Do not attempt to establish the settings for the speed and acceleration/deceleration above
the allowable range.
An operation with speed and acceleration/deceleration beyond the allowable range may cause an abnormal
noise, vibration, malfunction or shortened life.
2. Set the allowable load of the move on rod tip within the allowable range.
An operation with the load beyond the allowable load of the move on rod tip may cause an abnormal noise,
vibration, malfunction or shortened life. If it is extreme, flaking may occur on the guide.
3. Set the load offset distance within the allowable range.
Attaching a load with an load offset distance above the allowable range may cause vibration and abnormal
noise.
4. If back and forth operations are performed repeatedly in short distance, it may wear out the
film of grease.
Continuous back and forth operation within a distance less than 30mm may cause wear of grease.
As a reference, have approximately 5 cycles of back and forth operation in a distance more than 50mm in
every 5,000 to 10,000 cycles to regenerate the oil film. Keep using the actuator with the grease worn out may
cause malfunction. If it is extreme, flaking may occur on the guide.
5. Do not attempt to hit the rod against an abstacle with high speed.
It may destroy the coupling.
6. Make sure to attach the actuator properly by following this instruction manual.
Using the product with the actuator not being certainly retained or affixed may cause abnormal noise,
vibration, malfunction or shorten the product life.
7. Ensure use of the product in the specified conditions, environments and ranges.
An operation out of the guarantee may cause a drop in performance or malfunction of the product.