IAI America RCP4-RA6R - Manual (Page 36)

1. Checking the Product
30
(Left Reversed) (Right Reversed)
ML MR
1.3 Options
1.3.1 Brake Type (Model: B)
The brake is a mechanism designed to prevent the rod from dropping on a vertically installed actuator when the
power or servo is turned OFF.
Use the brake to prevent the installed load, etc., from being damaged due to the falling rod.
1.3.2 Reversed–home Specification (Model: NM)
The standard home position is on the motor side. However, the motor position will be reversed if it is desirable in
view of the layout of the system, etc.
(Note) The home position is adjusted at the factory before shipment. If you wish to change the home after the
delivery of your actuator, you must return the actuator to IAI for adjustment.
1.3.3 Flange Bracket (Front) (Model: FL)
This is the flange bracket to attach on the front of the main unit. The model code is indicated with FL.
1.3.4 Scraper (Model: SC)
It is attached on the part where the rod moves in and out to prevent dust from getting inside the unit from the
outside. (This is an option already attached when it is shipped out from the factory. It is necessary to dismantle
and assemble back if it is required to be attached afterwards.)
1.3.5 Motor Left Reversed, Motor Right Reversed (Model No. : ML, MR)
From the view of the motor side, the type with the motor reversed to the left is ML, and the motor reversed to the
right is MR.
Scraper