IAI America ISPDACR-ESD - Manual (Page 87)

79
12. Motor Replacement Procedures
(14) Install the rear cover.
Store the connectors in the space below the motor, and use an Allen wrench of 4 mm across flats to
tighten the hexagonal socket head bolts (M5 x 15 x 2 pcs) by paying attention not to pinch the cables.
(15) Tighten the hexagonal socket head button bolts affixing the side cover and stainless sheet retainer
plate using an Allen wrench of 2.5 mm across flats.
When doing this, adjust the countermarks of the sheet and side cover. Also remember to insert a
urethane sheet between the retainer plate and stainless sheet.
(16) Wipe off the countermarks using a waste cloth moistened with alcohol.
Store the connectors in the space below
the motor.
Tightening torque 342 N-cm (34.9 kgf-cm)
Affixing bolt for stainless sheet retainer plate:
Hexagonal socket head button bolt (M4 x 6 x 2 pcs)
Align the countermarks.
Side cover affixing bolt : Hexagonal
socket head button bolt (M4 x 8 x 2 pcs)
Button bolt tightening torque: 191 N-cm (19.5 kgf-cm)