IAI America DS-S-T1 - Manual (Page 52)

Page 50
10. Explanation on Each Function Screen
You may move Position No.1 through 2000, or input a number
directly.
(For the DS type, you may move position No. 1 through 500.)
Please refer to Page 16, section 8.1, entitled, “Creating
Position Data” for input procedure.
F1 F2 F3 F4
Axis+ Axis- Vel Etc
Use either the Axis+ or Axis- to move the cursor until it has
reached Axis 5. Then, once again, select Etc.
Position Input Mode
You may numerically input a position.
Position Input Mode Screen
Teac
Mdi
Step
Etc
Wrt
Can
Clr
Etc
Inc
Dec
Clr
Etc
↵
The screen has the following two methods:
Mdi - 1 No 1 [1] - 8
100.000 100. 000
100.000 100. 000
Axis 1
Axis 3
Axis 2
Axis 4
F1 F2 F3 F4
Wrt Can Clr Etc
Mdi - 1 No 1 [1] - 8
100.000 100. 000
100.000 100. 000
When Etc is selected
F1 F2 F3 F4
Mdi Teac Step Etc
Mdi - 1 No 5 [5] - 8
100.000 100. 000
100.000 100. 000
↵
Continuously press the Return Key 4 times
Axis 5
Axis 7
Axis 6
Axis 8
The screen will change into the position input mode for Axis
5 though Axis 8.
Posi
Aprg
Teac
Step
Etc
Prog
Inc
Dec
Clr
Del
F1 F2 F3 F4
Inc Dec Clr Del
Mdi - 1 No 1 [1] - 2
xxxx.xxx xxxxx.xxx
200. 000
Mdi
Posi
When the number of actuator axes is over 5 axes,
the next screen will appear.