LevelOne IES-1085 - Manual (Page 102)

User Manual Page 102
switch_a(config)#
2. Usage:
Use this command to statically configure a bridge entry to forward matching frames.
3. Command Syntax:
bridge GROUP address MAC forward IFNAME VLANID
no bridge GROUP address MAC forward IFNAME VLANID
GROUP <1-1> Bridge-group ID used for bridging.
MAC the Media Access Control (MAC) address in the HHHH.HHHH.HHHH format.
IFNAME the interface on which the frame comes in.
VLANID The VID of the VLAN that will be enabled or disabled on the bridge <2-4094>.
4. Example:
The following example configures a bridge GROUP (1) to forward matching frames (MAC
address 2222.2222.2222) to the interface fe1 (port 1) in vlan VLANID (2):
switch_a(config)#bridge 1 address 2222.2222.2222 forward fe1 vlan 2
switch_a(config)#
Static-MAC-Entry Discard:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to statically configure a bridge entry to discard matching frames in a
particular VLAN.
3. Command Syntax:
bridge GROUP address MAC discard vlan VLANID
no bridge GROUP address MAC discard vlan VLANID
GROUP <1-1> Bridge-group ID used for bridging.
MAC the Media Access Control (MAC) address in the HHHH.HHHH.HHHH format.
VLANID The VID of the VLAN on the bridge <1-4094>.
4. Example:
The following example configures a bridge GROUP (1) to discard matching frames (MAC
address 2222.2222.2222) in vlan VLANID (1):
switch_a(config)#bridge 1 address 2222.2222.2222 discard vlan 1
switch_a(config)#