LevelOne IES-1085 User Manual

Page 151

Advertising
background image

User Manual

Page 151

The switch_a(config)# prompt will show on the screen.

switch_a(config)#


6. Usage:
Use ntp enable command to enable NTP for the Switch.
Use no ntp enable command to disable NTP for the Switch.

7. Command Syntax:
(no) ntp enable

8. Example:
The following example enables NTP for the Switch:

switch_a(config)#ntp enable
switch_a(config)#


NTP Server:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.

switch_a(config)#


2. Usage:
Use this command to specify the IP address or Domain name of NTP server.

3. Command Syntax:
ntp server IP-ADDRESS|DOMAIN-NAME

IP-ADDRESS A.B.C.D specifies the IP address of NTP server.
DOMAIN-NAME Specifies the Domain name of NTP server.


4. Example:
The following example specifies the IP address (192.168.1.100) of NTP server:

switch_a(config)#ntp server 192.168.1.100
switch_a(config)#


Sync Time:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.

switch_a(config)#


2. Usage:
Use ntp sync-time command to synchronize time with NTP server.

Advertising