LevelOne IES-1085 User Manual
Page 95
User Manual
Page 95
LEVEL Threshold value -128 ~ 128℃.
4. Example:
The following example sets high temperature alarm threshold 100℃ for SFP transceiver
of interface ge1 (port G1):
switch_a(config)#sfp set-temp ge1 high-alarm 100
switch_a(config)#
Voltage Alarm (Warning) Threshold:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set voltage alarm (warning) threshold for SFP transceiver.
3. Command Syntax:
sfp set-vcc IFNAME high-alarm|high-warning|low alarm|low warning LEVEL
IFNAME specifies the name of the interface for which status and configuration
information is desired.
LEVEL Threshold value 0 ~ 6.55 volts.
4. Example:
The following example sets high voltage alarm threshold 6 volts for SFP transceiver of
interface ge1 (port G1):
switch_a(config)#sfp set-vcc ge1 high-alarm 6
switch_a(config)#
Tx-bias Alarm (Warning) Threshold:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set transmitter laser bias alarm (warning) threshold for SFP
transceiver.
3. Command Syntax:
sfp set-tx-bias IFNAME high-alarm|high-warning|low alarm|low warning LEVEL
IFNAME specifies the name of the interface for which status and configuration
information is desired.