LevelOne IES-1085 - Manual (Page 94)

User Manual Page 94
3. Command Syntax:
show interface IFNAME
IFNAME specifies the name of the interface for which status and configuration
information is desired.
4. Example:
The following example shows the use of show interface to display interface configuration
and status of the interface fe1 (port 1):
switch_a>show interface fe1
Alarm Situation:
1. Command Mode: Privileged Exec mode
Logon to Privileged Exec Mode (Enable Mode).
The switch_a# prompt will show on the screen.
switch_a#
2. Usage:
Use the show sfp-alarm-trigger command to show the information of SFP alarm trigger
including temperature, Vcc, Tx_bias, Tx_pow and Rx_pow.
3. Command Syntax:
show sfp-alarm-trigger IFNAME
IFNAME specifies the name of the interface for which status and configuration
information is desired.
4. Example:
The following example shows the use of show sfp-alarm-trigger to display the
information of SFP alarm trigger of the interface ge1 (port G1):
switch_a#show sfp-alarm-trigger ge1
Temperature Alarm (Warning) Threshold:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set temperature alarm (warning) threshold for SFP transceiver.
3. Command Syntax:
sfp set-temp IFNAME high-alarm｜high-warning｜low alarm｜low warning LEVEL
IFNAME specifies the name of the interface for which status and configuration
information is desired.