Teledyne LeCroy PXA125 - Manual (Page 152)

User Manual PXA125
Programming Reference 4-34
Purpose
This command is a high-level command that programs the PXA125 to output triangular waveform along with
its associated parameters
•
<freq> sets the output frequency in units of hertz
•
<ampl> sets the output amplitude in units of volts
•
<offs> sets the output offset in units of volts
•
<phase> sets the output start phase in units of degrees
Parameter type
Numeric
Parameter range
<freq> 10e3 to 50e6
<ampl> 80e-3 to 80
<offs> -3.6 to +3.6
<phase> 0 to 360
APPLy:TRIangle?
Response
The PXA125 will return <freq>, <ampl>,<offs>,<phase>. Default values are
1e6,5,0,0
APPLy:SQUare{<freq>,<ampl>,<offs>,<duty_cycle>}
Purpose
This command is a high-level command that programs the PXA125 to output square waveform along with its
associated parameters
•
<freq> sets the output frequency in units of hertz
•
<ampl> sets the output amplitude in units of volts
•
<offs> sets the output offset in units of volts
•
<duty_cycle> sets the squarewave duty cycle in units of %
Parameter type
Numeric
Parameter range
<freq> 10e3 to 50e6
<ampl> 80e-3 to 8
<offs> -3.6 to +3.6
<duty_cycle> 0 to 360
APPLy:SQUare?
Response
The PXA125 will return <freq>,<ampl>,<offs>,<duty_cycle>. Default values are
1e6,5,0,50
APPLy:PULSe{<freq>,<ampl>,<offs>,<delay>,<rise>,<high>,<fall>}
Purpose
This command is a high-level command that programs the PXA125 to output pulse waveform along with its
associated parameters