Teledyne LeCroy PXA125 - Manual (Page 153)

User Manual PXA125
Programming Reference 4-35
•
<freq> sets the output frequency in units of hertz
•
<ampl> sets the output amplitude in units of volts
•
<offs> sets the output offset in units of volts
•
<delay> sets the delay to the pulse rise transition in units of %
•
<rise> sets the pulse rise time in units of %
•
<high> sets the pulse high time in units of %
•
<fall> sets the pulse fall time in units of %
Parameter type
Numeric
Parameter range
<freq> 10e3 to 50e6
<ampl> 80e-3 to 8
<offs> -3.6 to +3.6
<delay> 0 to 99.9
<rise> 0 to 99.9
<high> 0 to 99.9
<fall> 0 to 99.9
APPLy:PULSe?
Response
The PXA125 will return <freq>, <ampl>,<offs>,<delay>,<rise>,<high>,<fall>.
Default values are
1e6,5,0,10,10,10,10
APPLy:RAMP{<freq>,<ampl>,<offs>,<delay>,<rise>,<fall>}
Purpose
This command is a high-level command that programs the PXA125 to output ramp waveform along with its
associated parameters
•
<freq> sets the output frequency in units of hertz
•
<ampl> sets the output amplitude in units of volts
•
<offs> sets the output offset in units of volts
•
<delay> sets the delay to the pulse rise transition in units of %
•
<rise> sets the pulse rise time in units of %
•
<fall> sets the pulse fall time in units of %
Parameter type
Numeric
Parameter range
<freq> 10e3 to 50e6
<ampl> 80e-3 to 80
<offs> -3.6 to +3.6
<delay> 0 to 99.9
<rise> 0 to 99.9
<fall> 0 to 99.9