Teledyne LeCroy PXA125 - Manual (Page 180)

User Manual PXA125
Programming Reference 4-62
INSTrument:COUPle:PHASe<phase>
Purpose
This command will program the phase offset between master and slave units. This command has no effect on
the instrument in modes other than instrument couple.
•
<phase> will set the leading edge offset between master and slave units
Parameter type
Numeric (integer only)
Parameter range
<phase> 0 to “n” in units of waveform points, where “n” is the size of the active segment. The phase
offset can be programmed in increments of 4 points.
INSTrument:COUPle:PHASe?
Response to query version
The PXA125 will return the present phase offset value. Default value is 0.
INSTrument:SET {0|1|2}
Purpose
This command will prepare the master and slave units for multi-instrument synchronization. The procedure
how to synchronize multiple instruments is given below.
Parameter type
Numeric (integer only)