Teledyne LeCroy SAS Sample Test Suite - Manual (Page 57)

SAS Sample Test Suite
Connection Errors (Test Group D) 57
DONE Timeout (TestD.2)
If, after sending DONE or DONE (CREDIT TIMEOUT), the target does not receive DONE, or a frame,
within 1 msec, then a DONE timeout condition exists. The Target device shall transmit a BREAK
primitive sequence.
Test Procedure:
1. The Testing Station is instructed to start and complete a phy Reset sequence followed by an
Identify sequence with the DUT. Since the DUT is a target, the Testing Station is instructed
to transmit an Identify Address frame indicating that it is an initiator.
2. The Testing Station is instructed to open an SSP connection to the DUT.
3. Wait for the DUT to transmit OPEN_ACCEPT and RRDY. The Testing Station is instructed to
transmit a READ BUFFER of 1024 byte to the DUT then close the connection.
4. Wait for the DUT to open an SSP connection to the Testing Station. The Testing Station is
instructed to one transmit RRDY to grant credit for the DUT to transmit a SCSI DATA frame
to the Testing Station. Test Station will ACK but not send a DONE in response to DUT DONE.
5. Wait 1 ms for the DUT to send the BREAK (6 primitives) and instruct the Testing Station to
reply with BREAK.
Observable Results: Verify that the DUT transmits a BREAK primitive sequence after a 1 ms
timeout.