Teledyne LeCroy SAS Sample Test Suite - Manual (Page 8)

SAS Sample Test Suite
Installation, Configuration and Operation 8
ATS Selection or Manual Operations
Using ATS to run multiple tests
To execute the SAS Test Script with the Automated Test Suite, the operator must setup the
application to reference the SAS Test environment.
As an example below for ATS, the SAS Test Scripts was located in the system Program Files under
the LeCroy SAS Analyzer.
Using the ATS GUI to select the test to run, start the selected test.
Running Individual Test Manually
To run an individual test script, it will require the operator to use the Analyzer and Trainer GUI.
Below are the steps needed to run it manually.
1. Start Analyzer and Connect to the Hardware you wish to use. Hardware wiring is Target Port
1 to Target device and Power cable to device as well.
2. Open “Configuration” pull down and select the “Software Setting” and update the “User
path:” field with the the location of the SAS Test Scripts and save with OK.
3. If a Project file is open and not the SAS Test version, close the Project window. Open a
Project file (Pull down “File” select “OPEN” or hit the OPEN button) located in the Project
directory. Select the project matching the Hardware connected.