Vanguard DMOM‐600 - Manual (Page 26)

Auto‐Ohm 200 S3 / DMOM‐200 S3 / DMOM‐600 USER’S MANUAL REV 2
22
3.4.2. Performing a Test
Follow the steps below to perform a test:
a. Start from the “START‐UP” menu:
Press the [1] key (RUN TEST).
b. The following screen will be displayed:
1. YES
Press the [1] key (YES) if you would like to set the passing resistance range for a
test. The following screen will be displayed:
Enter the lower resistance limit for a passing test using the keypad. The screen
will be updated as shown below:
Press the [ENTER] key. The following screen will be displayed:
ENTER LOWER LIMIT:
(0 - 5 ohms)
480

ENTER LOWER LIMIT:
(0 - 5 ohms)
0

ENTER PASS/FAIL TEST
LIMITS?
1. YES
2. NO
1.RUN TEST
2.SETUP
3.QUICK TEST
time: 14:21:34
date: 05/24/11