Vanguard DMOM‐600 - Manual (Page 27)

REV 2 Auto‐Ohm 200 S3 / DMOM‐200 S3 / DMOM‐600 USER’S MANUAL
23
Enter the upper resistance limit for a passing test using the keypad. The screen
will be updated as shown below:
Press the
[ENTER]
key. Continue to step c.
2. NO
Press the [2] key (NO) if you do not want to enter the passing resistance range
for a test. Continue to step c.
NOTES
If using an Auto‐Ohm 200 S3 with the Dual Ground option, the following
screen will be displayed before the screen shown in step c:
1. NO
Press the [1] key (NO) if you are not using a current probe and do not
want to use the Dual Ground option. Continue to step c.
2. YES
Press the [2] key (YES) if you have connected an external current
probe and would like to use the Dual Ground option. The following
screen will be displayed:
CONNECT EXT CURRENT
PROBE TO GND CABLE.
ENSURE THAT THE PROBE
IS TURNED ON!
PRESS ANY KEY
GROUND CURRENT PROBE?
(REDUCED ACCURACY)
1. NO
2. YES
ENTER UPPER LIMIT:
(0 - 5 ohms)
520

ENTER UPPER LIMIT:
(0 - 5 ohms)
0
