Vanguard DigiTMR S2 User Manual
Page 48
DIGITMR S2 USER’S MANUAL
REV 1
43
3.4.6. Setting the Default Printing Mode
The DigiTMR S2 can be configured to either print the test results automatically after each test,
or to print them by user request. Use the steps below to set the preferred printing method:
a. Start from the “START-UP” menu:
Press the
[3]
key (SET-UP).
b. The following screen will be displayed:
Press the
[5]
key (NEXT PAGE).
c. The following screen will be displayed:
Press the
[2]
key (SET PRINT MODE).
d. The following screen will be displayed:
SET PRINT MODE:
1. AUTOMATIC PRINT
2. BY REQUEST ONLY
1. SET DATE & TIME
2. SET PRINT MODE
3. SET 50/60 HZ
4. SET LANGUAGE
5. BLUETOOTH DEV RESET
6. PREVIOUS PAGE
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. SHOT DESCRIPTION
5. NEXT PAGE
1. TIME BREAKER
2. GET RESULTS
3. SETUP
4. DIAGNOSTICS