Vanguard DigiTMR S2 - Manual (Page 86)

DIGITMR S2 USER’S MANUAL REV 1
81
3.10.3. Restoring a Test Shot
Use the steps below to restore a test record from the DigiTMR S2’s internal Flash EEPROM or a
connected USB Flash drive to the working memory:
a. Start from the “START-UP” menu:
Press the [3] key (SETUP).
b. The following screen will be displayed:
Press the [3] key (SAVE / RESTORE).
c. The following screen will be displayed:
NOTE
Option 5 (COPY TO THUMB DRIVE) will be listed only if a USB Flash drive is
connected to the unit.
Press the [2] key (RESTORE SHOT).
If a USB flash drive is connected, continue to step d.
If a USB flash drive is NOT connected, continue to step e.
1. SAVE SHOT
2. RESTORE SHOT
3. SHOT DIRECTORY
4. ERASE SHOT
5. COPY TO THUMB DRIVE
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. SHOT DESCRIPTION
5. NEXT PAGE
1. TIME BREAKER
2. GET RESULTS
3. SETUP
4. DIAGNOSTICS