Vanguard DigiTMR S2 - Manual (Page 68)

DIGITMR S2 USER’S MANUAL REV 1
63
3.8.3. Checking Cable Hookups
To check the cable hookups:
a. Start from the “START-UP” menu:
Press the [4] key (DIAGNOSTICS).
b. The following screen will be displayed:
Press the [2] key (CHECK HOOKUP).
c. The following screen will be displayed:
Confirm that the breaker is in closed position and then press the
[START]
key.
d. The test results will be displayed on the screen as shown below and also printed on the
thermal printer:
1 2 3
C - -
MAKE SURE BREAKER IS
IN CLOSED POSITION
THEN PRESS "START"
1. SLOW CLOSE TEST
2. CHECK HOOKUP
3. TEST TRANSDUCER
4. PRINT DATA
5. ENCODER FILTER
6. CONTACT FILTER
1. TIME BREAKER
2. GET RESULTS
3. SETUP
4. DIAGNOSTICS