Vanguard DigiTMR S2 - Manual (Page 99)

REV 1 DIGITMR S2 USER’S MANUAL
94
3.11.2. Printing a Breaker Test Plan
To print a breaker test plan:
a. Start from the “START-UP” menu:
Press the [3] key (SETUP).
b. The following screen will be displayed:
Press the
[1]
key (ANALYSIS POINTS).
c. The following screen will be displayed:
Press the
[4]
key (TEST PLANS).
d. The following screen will be displayed:
Press the
[2]
key (PRINT TEST PLAN).
1. LOAD TEST PLAN
2. PRINT TEST PLAN
3. PRINT DIRECTORY
1. OPEN TIMING
2. CLOSE TIMING
3. PRINT SETTINGS
4. TEST PLANS
1. TIME BREAKER
2. GET RESULTS
3. SETUP
4. DIAGNOSTICS
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SAVE / RESTORE
4. SHOT DESCRIPTION
5. NEXT PAGE