Vanguard IRM-5000P - Manual (Page 46)

IRM-5000P USER’S MANUAL REV 2
42
3.2.3. Printing a Test Record from the Working Memory
After performing a test, the results are stored in the IRM-5000P’s working memory. The
tabulated results, resistance plot, and current plot can then be printed. Also, if a record is
restored from the unit’s Flash EEPROM to the working memory, the test results can be printed
on the thermal printer. Use the steps below to print a test record from the working memory:
a. Either perform a test or restore a test record from the Flash EEPROM. Then start from
the “START-UP” menu:
Press the [2] key (UTILITIES).
b. The following screen will be displayed:
Press the [1] key (PRINT).
c. The following screen will be displayed:
1. PLOT R
Press the
[1]
key (PLOT R) to print the resistance versus time graph. The graph
will be printed on the thermal printer and you will be returned to the “START-
UP” menu.
2. PLOT I
Press the [2] key (PLOT I) to print the current versus time graph. The graph will
be printed on the thermal printer and you will be returned to the “START-UP”
menu.
3. PLOT R,I
Press the [3] key (PLOT R,I) to print both the resistance versus time graph and
the current versus time graph. The graphs will be printed on the thermal printer
and you will be returned to the “START-UP” menu.
1.PLOT R 2.PLOT I
3.PLOT R,I 4.SUMMARY
TERMINAL VTG: 1 V
1.PRINT 2.SAVE/RES
3.SETUP
TERMINAL VTG: 1 V
1. RUN TEST 05/05/10
2. UTILITIES 15:15:15
Bat:
TERMINAL VTG: 1 V