ZOLL R Series Monitor Defibrillator Rev D - Manual (Page 11)

Cleaning and Reuse of Sensors
9650-0901-01 Rev. D R Series Pulse Oximetry (SpO
2
) 9
8. Connect the SpO
2
patient cable to the SpO
2
connector on the rear panel of the R Series unit.
Cleaning and Reuse of Sensors
Reusable sensors can be cleaned as follows:
1. Disconnect the sensor from the patient cable.
2. Wipe the entire sensor clean with a 70% isopropyl alcohol moistened pad.
3. Allow the sensor to air dry before returning it to use.
Cleaning and Reuse of Patient Cables
Patient cables can be cleaned as follows:
1. Disconnect the sensor from the patient cable (if attached).
2. Disconnect the cable from the rear of the R Series unit.
3. Wipe the cable clean with a 70% isopropyl alcohol moistened pad.
Allow the cable to dry before using it.
3P/
SpO
2
Cable Connector