IEI Integration NANO-LX v1.21 - Manual (Page 100)

NANO-LX EPIC SBC
Page 85
Figure 5-9: LPT Cable Connection
Step 4: Attach the LPT connector to the chassis. To secure the LPT interface
connector to the chassis please refer to the installation instructions that came
with the chassis.
Step 5: Connect LPT device. Once the LPT interface connector is connected to the
chassis, the LPT device can be connected to the LPT interface connector. See
Figure 5-10. Step 0:\
Figure 5-10: Connect the LPT Device
5.8.6 Single RS-232 Cable
The single RS-232 cable consists of one serial port connectors attached to a serial
communications cable that is then attached to a D-sub 9 male connector. To install the
single RS-232 cable, please follow the steps below.