IEI Integration NANO-LX v1.21 - Manual (Page 95)

NANO-LX EPIC SBC
Page 80
The NANO-LX must be installed in a chassis with ventilation holes on the sides allowing
airflow to travel through the heat sink surface. In a system with an individual power supply
unit, the cooling fan of a power supply can also help generate airflow through the board
surface.
NOTE:
IEI has a wide range of backplanes available. Please contact your
NANO-LX vendor, reseller or an IEI sales representative at
[email protected] or visit the IEI website ( http://www.ieiworld.com.tw )
to find out more about the available chassis.
5.7.2 Motherboard Installation
To install the NANO-LX motherboard into the chassis please refer to the reference
material that came with the chassis.
5.8 Internal Peripheral Device Connections
5.8.1 Peripheral Device Cables
The cables listed in Table 5-9 are shipped with the NANO-LX.
Quantity Type
1 ATA 66/100 flat cable
1 AT power cable
1 Audio cable
2 Single RS-232 cable
1 KB/MS Y cable
2 SATA drive cable
1 SATA drive power cable
Table 5-9: IEI Provided Cables