IEI Integration NANO-LX v1.21 - Manual (Page 98)

NANO-LX EPIC SBC
Page 83
Step 3: Connect Power Cable to Power Supply. Connect one of the 4-pin (1x4) Molex
type power cable connectors to an AT power supply. See Figure 5-7. Step 0:
Figure 5-7: Connect Power Cable to Power Supply
5.8.4 Audio Kit Installation
The Audio Kit that came with the NANO-LX connects to the audio connector on the
NANO-LX. The audio kit consists of three audio jacks. Mic-in connects to a microphone.
Line-in provides a stereo line-level input to connect to the output of an audio device.
Line-out, a stereo line-level output, connects to two amplified speakers. To install the
audio kit, please refer to the steps below:
Step 1: Locate the audio connector. The location of the 10-pin audio connector is
shown in Chapter 3.
Step 2: Align pin 1. Align pin 1 on the on-board connector with pin 1 on the audio kit
connector. Pin 1 on the audio kit connector is indicated with a white dot. See
Figure 5-8.