IEI Integration uIBX-210-CV-N2600 - Manual (Page 43)

u IBX-210-CV-N2600 Em b e d d e d S ys te m
P a g e 30
Figure 3-25: RS-422/485 Cable
S te p 3: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the RS-422/485 cable.
S te p 4: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
3.8.6 US B De vic e Co n n e c tio n
There are four USB 2.0 connectors on the uIBX-210-CV-N2600. To connect a USB device,
please follow the instructions below.
S te p 1: Locate the USB connectors. The locations of the USB connectors are shown
in Chapter 1.
S te p 2: Align the connectors. Align the USB device connector with one of the
connectors on the uIBX-210-CV-N2600. See Figure 3-26.
Figure 3-26: USB Device Connection