IEI Integration uIBX-210-CV-N2600 - Manual (Page 59)

u IBX-210-CV-N2600 Em b e d d e d S ys te m
P a g e 46
S te p 9: Connect the SATA connector (JSATA2).
S te p 10: Replace the back cover and secure it using eight (8) previously removed
retention screws.
5.4.2 Me m o ry Mo d u le Re p la c e m e n t
If the memory module fails, follow the instructions below to replace the memory module.
S te p 1: Remove eight (8) retention screws from the back cover. See Section 5.4.1.
S te p 2: Remove HDD module. See Section 5.4.1.
S te p 3: Locate the memory module indicated below.
Figure 5-6: uIBX-210-CV-N2600 SO-DIMM Socket Location
S te p 4: Remove the DDR3 memory module by pulling both the spring retainer clips
outward from the socket.
S te p 5: Grasp the DDR3 memory module by the edges and carefully pull it out of the
socket.
S te p 6: Install the new DDR3 memory module by pushing it into the socket at an angle
(Figure 5-7).