IEI Integration RPC-6022G - Manual (Page 50)

RPC-6022GW Rackmount LCD Workstation
Page 50
Step 1:
Step 2:
4.5.8 Install the CPU Card
CAUTION:
Before a CPU card is inserted into the backplane, make sure the CPU
card has been correctly prepared and that all the CPU card jumper
settings are configured correctly. For CPU card component installation
procedures, please refer to the user manual that came with the CPU
card.
CAUTION:
Depending on the location of the CPU card, the disk drive ribbon cable
connectors and other peripheral device cable connectors may have to
be connected to the CPU card before it can be installed.
To install a CPU card onto the backplane, follow the instructions below:
Remove the slot cover retention screw to remove the slot bracket from the
chassis rear panel (Figure 4-12).
Remove two card bracket screws to remove the card bracket from the fan
bracket (Figure 4-12).