2 upgrading the fw, Figure 5-21: fw upgrade – IEI Integration ITDB-100L User Manual
Page 62
Advertising
ITDB-100L Barcode Reader
Page 53
5.10.2 Upgrading the FW
Follow the steps below to upgrade the FW.
Step 1:
Click FIRMWARE on the left pane of the setup tool to bring up the Firmware
Upgrade menu (Figure 5-21).
The user can check the current firmware version from the menu.
Step 2:
Click Path to locate the firmware file.
Step 3:
Click Upgrade F/W to start updating the firmware.
Figure 5-21: FW Upgrade
Step 4:
When the FW upgrade
is complete, the ITDB-100L restarts automatically.
Step 5:
If the FW upgrade is failed or the ITDB-100L is failed to reboot, the user needs to
put the ITDB-100L into the backup mode and upgrade the device FW in the
backup mode. Refer to Section 5.10.3 on how to enter and exit the backup
mode.
Advertising