IEI Integration ITDB-100L - Manual (Page 71)

ITDB-100L Barcode Reader
Page 62
6.5.5 Setting an Image to Training Mode
The user can set a scanned barcode as a sample image so that the barcode reader
decodes only the same barcode type and size. Follow the steps below to set a barcode
image to training mode by using the Android app.
NOTE:
The training mode function can also be enabled by using the PC setup
tool or the trigger and tuning control button. Refer to Section 5.6.2 for
details.
Step 1: Tap to start the training mode function.
Step 2: Four beeps are being generated, the illumination LEDs start to flash and the
training mode button turns to , indicating that the training mode timer is
started.
Step 3: The user has to tap or to trigger the ITDB-100L within twelve
seconds after the timer is started.
Step 4: When successfully set a barcode as a sample image, two beeps should be
generated and the training mode button turns to ,
If the barcode training is failed, four beeps will be generated.
Step 5: To disable the training mode, tap .