SaltDogg SHPE1500 Series Electric Drive Poly Hopper Spreader v.2 - Manual (Page 4)

4
Fig. 6
Controller Warnings
Check controller instruction sheet for latest controller
updates and troubleshooting codes. Controller instruc-
tion sheet is inside controller shipping box.
IMPORTANT! INSTALLER, DO NOT DISCARD
CONTROLLER INSTRUCTION SHEET. STAPLE SHEET
TO SPREADER MANUAL AND GIVE TO END USER!
Note: To unclog auger manually, first remove the chute.
Apply 1¼" open wrench on auger’s nut. Turn auger
counterclockwise several times.
Note: Do not run the vibrator longer than 30 minutes
with 15 minutes between runs to avoid overheating.
Spreader Maintenance
1. Wash spreader after every use. Make sure no mate-
rial is left under auger and/or inside trough.
2. Inspect and retighten fasteners after every 5-7 hours
of operation.
3. Lubricate bearing every 7-10 hours of operation using
general automotive grease.
4. Inspect terminals/connectors every time you discon-
nect spreader from wire harness. Apply thin layer
of dielectric grease on terminals. If any tarnish/cor-
rosion is found, clean terminals and apply dielectric
grease.
5. Use dielectric grease on all electrical connectors
before an electrical connection is made or after con-
nector is disconnected
6. Grease and spray with lubricant Auger bearing after
every 20 hours of use.
7. Empty the spreader of all ice control materials when
not in use. Wash out the spreader to prevent material
builds up.
8. It is recommended to cover spreader with the tarp
during storage periods. Tarp can be attached to
anchors on both sides of tie downs.
End of Season Maintenance
1. Wash spreader. Make sure no material or residue is left
in and outside the hopper.
2. Lubricate bearing using general automotive grease.
3. Inspect wire harness, connectors for broken insulation,
missing components. Replace if necessary.
4. Apply dielectric grease on all electrical connectors.
5. Store hopper indoors, in a dry, cool place.
6. Remove controller from truck. Store controller indoors,
in a dry, cool place.
Summer Storage
1. Apply dielectric grease or similar protective compound
on all electrical connectors & protect them with caps
before storage.
2. Disconnect and remove speed controller from vehicle
and store it in dry and cool place. Protect controller
from excessive heat and moisture.
3. Clean hopper and trough from all kinds of debris.
4. Remove, thoroughly lubricate and reinstall trough
bearing.
5. Protect hopper from excessive temperatures during
summer storage.
WARNING
Always disconnect power when servicing spreader.
CONNECT
CONNECT
CONNECT
CONTROLLER #3014199
WIRE 36" LONG
#0203700
POWER CABLE
#3006842
MAIN WIRE
HARNESS #3006724
FUSE CONNECTOR
CONNECT TO FUSE
TERMINAL OR
IGNITION SWITCH
CONNECT TO
BATTERY
CONNECT TO CHUTE
CONNECT TO MOTOR
OPTIONAL
# 3018009
COMPARTMENT HARNESS
BROWN WIRE
CONNECT TO
UTILITY LIGHT
CONNECT TO
KNOWN GROUND