SaltDogg 92440SSA Series Under Tailgate Spreader - Manual (Page 5)

5
TM
CONNECT
CONNECT
CONNECT
CONNECT
CONNECT
CONNECT TO BATTERY
TERMINALS ONLY
CONNECT TO FUSE OR WIRE
IN FUSE PANEL CONTROLLED
BY IGNITION SWITCH
5 AMP MAX
CONNECT TO
CHUTE MOTOR
CONNECT TO CHAIN/ AUGER
GEAR MOTOR
CONNECT TO VIBRATOR
OPTIONAL
#3016944
#3016943
#0203700
#3016934
CONTROLLER
IMPORTANT
IMPORTANT Make sure all wires securely attached to
vehicle or spreader. Use wire ties and/or wire clamps
to attach wires. All excess wires must be rolled into
bungles and attached to vehicle or spreader.
Thoroughly clean battery terminals. Make sure battery
terminals have no tarnish or corrosion. DO NOT CONNeCT
WIRe HARNeSS TO DAMAGeD OR CORRODeD
TeRMINALS!
IT MAy ReSULT IN OveRHeATING, LOST POWeR AND
POTeNTIAL CONTROLLeR DAMAGe!
K. Connect the power cable directly to the battery.
l. Insure all functions of the controller are
working properly.
M. Observe auger moving in proper direction. If direction is
wrong reverse wires between Motor and Wire Harness.
n. Optional spot light (5 AMP max) can be installed on
spreader. Remove cap from single white wire. Connect light
to this wire and trucks frame.
ATTACH WIRE HARNESS TO LOWER
DOOR USING CLAMP HK1113 AND
WING NUT 3005723. LEAVE ENOUGH
WIRE SLACK TO PLUG CONNECTORS
TO GEAR MOTOR.
Figure 5