Maple Systems STEPware-100 - Manual (Page 25)

2. At Parameters?, press the OIT’s TOGGLE key to alternate between MODIFY and
VIEW, then press the OIT’s ENTER key to accept and continue.
Option Description Result
MODIFY Allows you to enter
Download/Upload mode or
modify the OIT’s current
operating parameters.
Displays Password? (refer to step 3)
NOTE: You must start entering your password
or press the OIT’s ENTER key within 5
seconds, or the OIT exits Configuration mode.
VIEW Displays the OIT’s current
operating parameters.
Displays the first operating parameter (refer to
step 5).
3. At Password?, type the setup password and then press the OIT’s ENTER key. If there is
no setup password, just press the OIT’s ENTER key. Down/Upload mode? Y displays.
4. At Down/Upload mode?, press the OIT’s TOGGLE key to alternate between Y and N,
then press the OIT’s ENTER key to accept and continue.
Option Description Result
Y Allows you to enter
Download/Upload mode
for communication with
STEPware-100.
Displays: Ready for Transfer
to/from STEPware!
Refer to Chapter 1: Getting Started for
instructions on creating and downloading a
STEPware-100 project.
N Displays the OIT’s current
operating parameters.
Displays the first operating parameter (refer to
step 5).
22 STEP1 Protocol Operation Manual
1010-0096, Rev. 04