Maple Systems STEPware-100 User Manual
Page 26
5. The following Level 1 menus appear in order. If you select YES at a Level 1 menu,
the corresponding Level 2 menus appear. If you select NO at a Level 1 menu, the next
Level 1 menu appears. At any menu, press the OIT’s TOGGLE key to alternate
between the options.
Level 1 Menus
Level 2 Menus
Options
OIT Brightness:
(MAP340D, OIT4100
Series, OIT4400,
OIT4450)
30%, 50%, 75%, 100%
Disp View Angle:
(MAP460D, OIT3100
Series, OIT3600)
75d, 90d
Modify communication
parameters?
Baud Rate:
Parity:
Data Length:
Stop Bits:
300, 600, 1200, 2400, 4800, 9600, 19200
NONE, ODD, EVEN, MARK, SPACE
7, 8
1, 2
Modify operating
parameters?
Op Mode:
Handshake:
Line Term:
Append LF:
Local Echo:
Block Echo:
Turn Delay:
Delayed LF:
RS485 3 Wire:
Network Address:
INTERACTIVE, BLOCK, NETWORK
NONE, XON/XOFF, RTS/CTS, BOTH
CR, LF, CR/LF, ETX
ENABLED, DISABLED
ENABLED, DISABLED
ENABLED, DISABLED
NONE, 50 MSEC, 100 MSEC, 250 MSEC
NO, YES
NO, YES
1 to 255
Modify display/keybd
parameters?
Tab Width:
Cursor:
Wrap Around:
Key board:
KeyClick:
Setup Access:
Setup Password
1 SPACE, 4 SPACES, 8 SPACES
UNDERLINE, NONE
ENABLED, DISABLED
ENABLED, DISABLED
ENABLED, DISABLED
NO, YES
5 numbers in any combination
Setup correct?
YES — saves changes and exits
Configuration mode.
NO — returns to Down/Upload mode?
(refer to step 4).
OIT Configuration
23
1010-0096, Rev. 04