Maple Systems STEPware-100 User Manual
Page 89
•
for OIT3165/4165, OIT3175/4175 and OIT3185/4185 models:
1. While pressing and holding down the CLEAR or ENTER key, cycle power to the
OIT. Continue pressing until the Disp View Angle or OIT Brightness message
is displayed, then release.
2. Press the ENTER key to display Baud Rate message.
3. Press the F1 key.
4. Press the F2 key.
5. Press the F3 key.
6. Wait for a few seconds. The OIT will reinitialize, allowing you to enter Local
Setup by holding down the CLEAR or ENTER key.
7. Refer to Chapter 2, OIT Configuration and follow instructions.
•
for OIT3200/3250 and OIT5400 models:
1. While pressing and holding down the CLEAR or ENTER key, cycle power to the
OIT. Continue pressing until the Baud Rate message is displayed, then release.
2. Press the F1 key.
3. Press the F2 key.
4. Press the F3 key.
5. Wait for a few seconds. The OIT will reinitialize, allowing you to enter Local
Setup by holding down the CLEAR or ENTER key.
6. Refer to Chapter 2, OIT Configuration and follow instructions.
•
for OIT4400/4450 models:
1. While pressing and holding down the CLEAR or ENTER key, cycle power to the
OIT. Continue pressing until the OIT Brightness message is displayed, then
release.
2. Press the ENTER key to display Baud Rate message.
3. Press the F1 key.
4. Press the F2 key.
5. Press the F3 key.
6. Wait for a few seconds. The OIT will reinitialize, allowing you to enter Local
Setup by holding down the CLEAR or ENTER key.
7. Refer to Chapter 2, OIT Configuration and follow instructions.
•
for OIT3600 model:
1. While pressing and holding down the CLEAR or ENTER key, cycle power to the
OIT. Continue pressing until the Display viewing angle message is displayed,
then release.
2. Press the ENTER key to display Baud Rate message.
3. Press the F1 key.
4. Press the F2 key.
5. Press the F3 key.
6. Wait for a few seconds. The OIT will reinitialize, allowing you to enter Local
Setup by holding down the CLEAR or ENTER key.
7. Refer to Chapter 2, OIT Configuration and follow instructions.
•
for MAP320/340/460 model:
1. Press and hold down the CLEAR or ENTER key while the OIT is initializing,
until the Display viewing angle message is displayed.
2. Press the ENTER key to display Baud Rate message.
F-2
STEP1 Protocol Operation Manual
1010-0096, Rev. 04