Network address setting, Tab width setting, Cursor type setting – Maple Systems STEPware-100 User Manual
Page 34
Network Address Setting
This parameter determines the network address used by the host controller to
communicate with this OIT when in Network mode. Options are 1 to 255.
To modify this parameter using STEPware-100:
1. Open the Configuration Editor.
2. In the OIT Operational Settings group box, enter the desired network address in the
Network Addr. text box.
To modify this parameter in Configuration mode:
1. At Network Address:, use the OIT’s TOGGLE key to select the desired network
address. Refer to the Configuration Mode section in this chapter for more
information.
To modify this parameter from the host controller:
1. Use the Set Operating Mode control command. Refer to Appendix A: Control
Commands for more information.
Tab Width Setting
This parameter determines how many spaces the OIT moves the cursor when the HT
control code (hexadecimal 09) is received from the host controller. Options are 1 Space, 4
Spaces, and 8 Spaces.
To modify this parameter using STEPware-100:
1. Open the Configuration Editor.
2. In the OIT Operational Settings group box, select the desired tab width in the Tab
Width list box.
To modify this parameter in Configuration mode:
1. At Tab Width:, use the OIT’s TOGGLE key to select the desired tab width. Refer to
the Configuration Mode section in this chapter for more information.
To modify this parameter from the host controller:
1. Use the Set Tab Character Width control command. Refer to Appendix A: Control
Commands for more information.
Cursor Type Setting
This parameter determines the type of cursor used in the OIT’s display. Options are No
Cursor and Underline.
To modify this parameter using STEPware-100:
1. Open the Configuration Editor.
2. In the OIT Operational Settings group box, select the desired cursor type in the
Cursor Type list box.
To modify this parameter in Configuration mode:
1. At Cursor:, use the OIT’s TOGGLE key to select the desired cursor type. Refer to the
Configuration Mode section in this chapter for more information.
OIT Configuration
31
1010-0096, Rev. 04