Maple Systems STEPware-100 User Manual
Page 75
The keyboard that is created using the STEPware-100 configuration software becomes
active only after the OIT has finished it’s initialization routines when power is applied to
the unit. Therefore, the user-defined keyboard becomes active only after the OIT has
displayed “Initializing” then “Terminal Now Ready!!”.
Between the time when power is first applied to the OIT and the time that the
user-defined keyboard becomes active, the OIT uses an alternate ‘setup’ keyboard which
allows the OIT programmer to gain access to the Setup menus. The ‘setup’ keyboard will
remain in effect while the OIT is in setup mode, until the OIT is reinitialized.
The templates below show how each key is defined when in setup mode:
D-2
STEP1 Protocol Operation Manual
1010-0096, Rev. 04
7
4
1
8
5
2
9
3
6
0
CLEAR
ENTER
Toggle
OIT3165/4165
F11
F9
F19
F17
F2
F10
F18
F3
F1
F4
F16
F24
F12
F20
F13
F5
F21
F14
F22
F6
F7
F8
F15
F23
OIT3185/4185