Yokogawa ADMAG AXW - Manual (Page 37)

<6. OUTLINE>
6-6
IM 01E25D11-01EN
n OPTIONAL SPECIFICATIONS (continued)
○
: Available – : Not available
Item Specifications
Applicable Model
Code General Submersible
AXW***G AXW***W
Hydrostatic Test The test verifies the absence of leaks by applying the following water pressures (which
are determined under process connection conditions) to lining for ten minutes. Test
results are described in the Note column of a test certificate(QIC).
Process Connection: Water Pressure:
EN PN6, EN PN10 (code CEK) 0.9 MPa
ASME Class 150, EN PN10 (code CE1), EN PN16, JIS 10K 1.5 MPa
AS2129 Table E, AS4087 PN16, JIS F12 (JIS 75M) 1.5 MPa
AWWA C207 Class D 1.25 MPa
AS2129 Table D 1.05 MPa
○ ○ T01
Calibration Certifi-
cate
Level 2: The Declaration and the Calibration Equipment List are issued. ○ ○ L2
Level 3: The Declaration and the Primary Standard List are issued. ○ ○ L3
Level 4: The Declaration and the Yokogawa Measuring Instruments Control System are
issued.
○ ○ L4
Five-point Calibra-
tion in User-specified
Span
A flow test near 0, 25, 50, 75, and 100% of the user-specified span is performed instead
of the flow test of the standard 2m/s span and a test certificate (QIC) is submitted.
Specify the span (100% flow span) whose corresponding flow velocity lies between 0.5
to 10 m/s and that is less than the maximum line capacity. Selectable range of flow rate
span is shown below.
Size : mm (in.) Selectable range of flow rate span : m 3 /h
(Flow rate span velocity : m/s)
500 (20) 354 (0.5) to 7068 (10.00)
600 (24) 509 (0.5) to 8200 (8.06)
700 (28) 693 (0.5) to 8200 (5.92)
800 (32) 905 (0.5) to 8200 (4.53)
900 (36) 1146 (0.5) to 8200 (3.58)
1000 (40) 1414 (0.5) to 8200 (2.90)
1100 (44) 1711 (0.5) to 8200 (2.40)
1200 (48) 2036 (0.5) to 8200 (2.01)
1350 (54) 2577 (0.5) to 30000 (5.82)
1400 (56) 2771 (0.5) to 30000 (5.41)
1500 (60) 3181 (0.5) to 30000 (4.71)
1600 (64) 3620 (0.5) to 30000 (4.14)
1800 (72) 4581 (0.5) to 30000 (3.27)
○ ○ SC