Yokogawa ADMAG AXW - Manual (Page 8)

<2. HANDLING PRECAUTIONS>
2-1
IM 01E25D11-01EN
2. HANDLING PRECAUTIONS
This instrument has been inspected carefully at
the factory before shipment. When the instrument
is delivered, visually check that no damage has
occurred during transportation.
Read this section carefully as it contains important
information on handling this instrument. Refer to
the relevant sections for information not contained
in this section. If you have any problems or
questions, please contact Yokogawa sales office.
2.1 Checking Model and
Specifications
The model code and specifications are found on
the data plate located on the outside of the case.
Check that the model code and specifications
match what you have ordered.
Be sure you have your model number and serial
number available when contacting Yokogawa.
F0201.ai
KCC-
REM-
YHQ-
EEN
165
Figure 2.1.1 Data Plate
2.2 Storage Precautions
If the instrument is to be stored for a long period of
time after delivery, observe the following points.
 The instrument should be stored in its original
packing condition in the storage location.
 Select a storage location that fulfils the following
conditions:
• A place where it will not be exposed to rain or
water
• A place subject to minimal vibrations or
shocks
• Temperature and humidity levels should be
as follows:
Temperature: -10 to 70°C
Humidity: 5 to 80% RH (no condensation)
The preferred ambient temperature
and humidity levels are 25°C and
approximately 65% RH.
 If the magnetic flowmeter is transferred to
the installation site and stored without being
installed, its performance may be impaired due
to the infiltration of rainwater and so forth. Be
sure to install and wire the magnetic flowmeter
as soon as possible after transferring it to the
installation location.
2.3 Installation Location
Precautions
Select the installation location with consideration
to the following items to ensure long-term stable
operation of the instrument.
n Ambient Temperature:
Avoid installing the instrument in locations
with constantly fluctuating temperatures. If the
location is subject to radiant heat from the plant,
provide heat insulation or improve ventilation.
n Atmospheric Condition:
Avoid installing the instrument in a corrosive
atmosphere. In situations where this is
unavoidable, consider ways to improve
ventilation and to prevent rainwater from
entering and being retained in the conduit
pipes.
n Vibrations or Shocks:
Avoid installing the instrument in a place subject
to shocks or vibrations.